Home
I call this piece "Instinct".  It is what nature is all about to me.  Creatures are focused on survival with the means they have at hand.  I started out with a late 1800's buckboard wagon wheel with a plow disc for the base.  Next I create the large fist from horse shoes and expanded metal. The smaller fish are made from horse shoes and mower teeth for the rear fin.  There are various water plants created from drill bits, tire chains, and pellet stove augers.

The fish on the left is made from horseshoes, skeleton key, expanded metal, and a plow disc for the base.

A plow disc forms the main body with a horseshoe finishing the hole I cut out of the plow disc.  Several pieces of 1/4" round bar make up the water plants, and 3/8" square stock make up the curved holder that holds up the fish.  The center circle in the stand was made from the bottom of a wine bottle.

misc show 187.jpg (111828 bytes)

This next piece is composed of recycled handles from forks, knives, and spoons.  It's approximately 24" long and eight" wide.  This piece has over 100 individual pieces

This next piece is composed of recycled handles from forks, knives, and spoons, and an old horse shoe.  It's approximately 24" long and eight" wide.  This piece has over 100 individual pieces

This alligator is made from a discarded muffler, two shovels, and four railroad spikes for feet.  His tail is composed of a piece of a fertilizer spreader.  Truly a unique piece that is very limited.

I used horseshoes and pin blanks to create this fist.  Call if you would like to order one for Christmas!

Here's another shot of the horse.  Very nice.

Picture 013.jpg (115924 bytes)

Here's the wrench fish.  We've been doing this in a number of ways over the years.  Sometimes with wrenches and pliers and sometimes with sheet metal.

Picture 030.jpg (138317 bytes)

This is one of our flying  fish that is created from a horse show, round bar, silverware, and flat steel.  It is perfectly balanced on an approximately 3 foot tall stake that goes into the ground.  These have been tested in our yard just off the Columbia River.  We normally have these in our shows from

misc show 100.jpg (109417 bytes)

Fear no fish!  That was what my father always used to say.  This guy is made from an old piece of round bar, horse shoes, skeleton key, expanded metal, and mowing machine teeth.

more metal 031.jpg (105918 bytes)

 
 

 

 © 2008 Clifton Metal Works